QRP Labs High Performance SDR Receiver

Features

• Three modules
  • QRP Labs High Performance Receiver Module
    • Direct Conversion Receiver
    • Uses a Quadrature Sampling Detector (QSD), also known as a Tayloe Detector
    • FST3253 Mixer is arranged as a double-balanced mixer for maximum performance
    • Circuit to mute receiver during transmit
    • Low noise LM4562 op-amps are used in instrumentation amplifier configuration to provide excellent common mode noise rejection
    • The audio output of the module is isolated using two 600:600-ohm transformers to reduce or eliminate the ground loop problems which can easily occur in SDR systems
    • The module is designed to directly drive a stereo input sound-card or with a polyphase filter card
    • Receiver board has a socket for the standard QRP Labs Band Pass Filter kit which can be routed to an external bandpass filter switch card
  • QRP Labs Band Pass Filter
    • Can be used with a Switched Bandpass filter board for multiband operation
  • QRP Labs Polyphase filter
    • Polyphase network plug-in module kit which cancels the unwanted sideband and produces a single sideband (SSB) output
• Band Pass Filter and Polyphase filter mount on Receiver Module
• The receiver requires a local oscillator (LO) input at 4x the receive frequency
  • Using VFO-003 with 4x output option
• Power supply
  • Needs 5V supply
  • Opamps can be powered from 5V or 12-14V (for higher dynamic range)
• The receiver module is sized 80 x 37mm

Radio Links

• High performance SDR receiver module
  • Build instructions
• Polyphase network module - QRP Labs
  • Build instructions
• RF_Band_Pass_Filters
  • 10/15/20/40/80M QRP Labs Band Pass Filter Kits
• Clocks Generator

Silkscreen / Pinout

• IQ pins
• I, GND, Q outputs
• Power pins
• GND, +5V, +5V or +12V to +14V
• Tx Mute Input
  • 5V mutes inputs
• LO input
  • 3.3V from Si5351A oscillators
• IF input
  • From external Bandpass Filter Switch

Bandpass Filter Installation