ER-VCA2-01

Features

• Eurorack card
  • 3U tall
  • 6HP wide
  • 3 card set
• Dual Voltage Controlled Amplifier (VCA)
• LM13700 based
  • LM13700 Operational Transconductance Amplifier
• Pots adjust between input and Mod jacks
  • CW - output is fully controlled by MOD jack
  • CCW - output is not controlled by MOD jack
• +/- 12V Power, 10-pin power connector

Credits

• Based on HAGIWO's LM13700 Dual VCA - Modular Synth Made for 550 Yen

Connectors

J1 - Daughtercard Pots

• POT1 = RV1 = Modulation Adjust Channel 1
• POT2 = RV2 = Modulation Adjust Channel 2

J2 - Daughtercard Eurorack Power

J3 - Daughtercard Control Card Jacks

• Controls card J3 = OUT1 (bottom left jack)
• Controls card J4 = OUT2 (bottom right jack)
• Controls card J5 = MOD1 (middle left jack)
• Controls card J6 = MOD2 (middle right jack)
• Controls card J7 = IN1 (top left jack)
• Controls card J8 = IN2 (top right jack)

Reference

• Dual Log/Linear VCA - Article by Ray Wilson
  • Has adjustment procedure

Checkout

Rev 2

• Headers line up
• Tested as set, works great
• View from rear side

Rev 1

• Headers between cards do not line up
  • Fix on Controls card
    • Make Rev 2 Controls card
    • Move down bottom header J2 to match daughtercard
  • Cut off 0.1" of controls card using vice/hacksaw
  • Use female headers on bottom of daughtercard
  • Use right angle pin header pins to connect to pads (remove plastic)

Assembly Sheet

• ER-VCA2-01 Rev 2 Controls Card Interactive BOM
• ER-VCA2-01 Rev 2 Daughtercard Interactive BOM
• ER-VCA2-01 Rev 2 Assembly Sheet
• ER-VCA2-01 Rev 1 Assembly Sheet