RPI PSOC5

Raspberry Pi Clone

Features

• Raspberry Pi Electrical and Mechanical Compatible
  • 40 pin GPIO connector
  • Connects to all GPIO pins of the Raspberry Pi
• Programmable System on a Chip (PSoC)
  • Cypress Semiconductor
• USB Micro connector
  • Placed in the same location as a Raspberry Pi
  • Provides 5V power
  • 5V power is polyfuse protected
• 3.3V regulator
• 3.3V or 5V I/O
  • H3 - Voltage Select Jumper
• On-board LED
  • PSOC Pin 5.4

Connectors

J1 - USB Power Connector

• USB Micro B

H1 - 40 Pin GPIO Connector

• BCM pin numbers

• PSOC5 to BCM mapping

H2 - Programming header

1. GND
2. RESET*
3. SWDCK
4. SWDIO

H3 - Power Select connector

• 1-2 = 3.3V
• 2-3 = 5V

H4 - 3.3V GPIO connector

1. 3.3V
2. 3.3V
3. 15.0
4. 15.1
5. 3.0
6. 3.1
7. 3.2
8. 3.3
9. 3.4
10. 3.5
11. 3.6
12. 3.7
13. 15.2
14. 15.3
15. GND
16. GND

H5 = 3.3V or 5V GPIO connector

1. VZ0
2. VZ0
3. 4.5
4. 4.4
5. 4.3
6. 4.2
7. 0.7
8. 0.6
9. 0.5
10. 0.4
11. 0.3
12. 0.2
13. 0.1
14. 0.0
15. 4.1
16. 4.0
17. 12.3
18. 12.2
19. GND
20. GND

Raspberry Pi Mechanicals

Drivers/Source Code

• Github Repository for the RPI_PSOC5

Schematic

• RPI_PSOC5 Schematic

Programming

• KitProg is a part of CY8CKIT-059
  • Fitted with 1x4 right angle header
• Programming cable
  • 4 pin 1:1 Dupont cable
  • USB A Male to female cable
• Has a CY8C5868LTI-LP039 used as the programmer
• CY8CKIT-059 Guide
• KitProg User Manual

• Program using PSOC Creator
• Select Debug, Program

• Select Device/connect

Factor Acceptance Test

• Raspberry Pi Test Station - Tests itself

Equipment

• Unit Under Test
  • RPI_PSOC5
• Host computer
  • Connected via Micro-USB cable
  • Running PuTTY
    • 115,200 baud
• LED-32 - LED Test Card
• Cable set from UUT to LED-32
• Load UUT card with RPI_PSOC5_Serial_01 test software

Assembly Sheet

• RPI_PSOC5 Assembly Sheet