RPIO-TINY-3

From Land Boards Wiki
Revision as of 11:39, 10 January 2020 by Blwikiadmin (talk | contribs) (Created page with "== Raspberry Pi GPIO Card == File:RPIO-TINY-3-5739-640px.jpg == Features == * Raspberry Pi add-on card ** Works with any Pi model * 17 GPIO lines ** GVS (Ground, Voltag...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Raspberry Pi GPIO Card

RPIO-TINY-3-5739-640px.jpg

Features

  • Raspberry Pi add-on card
    • Works with any Pi model
  • 17 GPIO lines
    • GVS (Ground, Voltage, Signal) connector for every GPIO pin
  • 3.3V operation
  • Fuse Protected 3.3V power
  • Card sits within Raspberry Pi footprint
    • Mounts above Raspberry Pi card

Connectors

  • G, V, S rows are marked on the board

File:RPIO-TINY-3-GPIOs.png

  1. Ground
  2. 3.3V
  3. Signal

Factory Acceptance Tests (FAT)

Hardware

FAT requires the following:

  • Raspberry Pi (RasPi)
  • Power supply for Raspberry Pi (5V at 1 Amp min) with Micro USB connector
  • Monitor, Keyboard or Ethernet cable and laptop running puTTY
  • Test Software loaded onto RasPi
  • (1) LED-Test-2 card
  • 1 LED with series resistor
  • Jumpers (female-to-female)
  • Unit Under Test (UUT)
  • RPIO-TINY-3-5725-WIRED-640px.jpg

Preliminary

  • Install UUT onto RasPi
  • Install Cables
  • Power up card
  • Log into RasPi

GVS Connector - LED Blink Tests

cd ~/RasPi/RPIO-TINY-3
sudo python blinkLEDs-RPIO-TINY-3.py
  • All 17 LEDs should light one at a time
Retrieved from "http://land-boards.com/blwiki/index.php?title=RPIO-TINY-3&oldid=1488"