UNI-OPAMP-04

8 opamp, SMT version

Features

• Universal OpAmp Board
  • Configurable for typical OpAmp circuits
• 4 Channels
• 1 Quad OpAmp
  • LM324 parts (typical) in DIP-14 package
    • 3V to 32V
  • Also supports lower voltage op amps such as MCP6004
    • 1.8V to 6V
  • SMT parts
• Individual input and output headers per channel
• Terminal block for power
• Bypass capacitors
• 59X49mm form factor
• (4) 4-40 mounting holes

Connectors

J1-J4 - Inputs

• Pinout

1. Opamp + input
2. Opamp - input
3. GND

• J1 - CH 1
• J2 - CH 2
• J3 - CH 3
• J4 - CH 4

J5-J8 - Outputs

• Pinouts

1. Opamp Out
2. GND

• J5 - CH 1
• J6 - CH 2
• J7 - CH 3
• J8 - CH 4

Configurations

• The reference designs (below) are for the first channel.

• The resistor mapping from the first channel on the schematic to the other channels are as follows.

Resistors by Channel

OpAmp	Ax-/Ix-	Ax+/Ix+	Ax-/Qx	Ax-/GND	Ax+/GND	Ax+/VCC
U1A	R3	R5	R1	R2	R4	R6
U1B	R10	R9	R12	R11	R7	R8
U1C	R22	R19	R24	R23	R21	R20
U1D	R15	R17	R13	R14	R16	R18

Reference Designs

• Reference drawings are from TI Ap Note 31
• Reference designators are for channel 1
  • See resistor values table (above) schematic for other channels

Differential Amplifier

Differential Amplifier - Reference Design

Differential Amplifier Stuffing Options

Current to Voltage Converter

Current to Voltage Converter - Reference Design

Voltage to Current Stuffing Options

Inverting Amplifier

Inverting Amplifier - Reference Design

Inverting Amplifier Stuffing Options

Non-inverting Amplifier

Non-inverting Amplifier - Reference Design

Non-inverting Stuffing Options

Schematic

• Schematic

Single Channel Schematic

Mechanicals