Front Panel For 8 Bit Computers

Front Panel for 8-Bit Microprocessors

Top row controls

Typical controls.

Features

It has these features. They may not fit your generic design. Especially since this card has to have an I2C interface.

• 32 Pushbutton Switches
• 32 LEDs
• I2C interface (Two Wire interface - plus power and ground)
  • Jumper selectable base address
  • Occupies I2C addresses either 0x20-0x23 or 0x24-0x27
  • Jumper Selectable I2C terminators
• I2C daisy-chain connector
  • Interrupt line
    • Can be configured to interrupt on button presses
    • MCP23017 need to be set to Open-Drain output - card has pull-up to Vcc
• 4 MCP23017 16-bit I2C Port Expanders
  • These are fine pitch surface mount parts
• 3.3V or 5V operation
• Compatible form factor with RETRO-EP4CE15 and other cards
  • 95x95mm
  • 6-32 mounting holes

Connector

J2 - I2C Connector

• Two row header on bottom of card
• 5 pin in
• 4 pin out (daisy-chain)

1. GND
2. VCC
3. SDA
4. SCL
5. INT*

And

1. GND
2. VCC
3. SDA
4. SCL

Schematic

• Front Panel Schematic Rev 1

Drivers

• VHDL code to control Front Panel autonomously - Great for FPGA Retro-computers
  • Example: 6800 running MIKBUG using the Front Panel - Run/Halt the CPU, Read SRAM, ROM, etc, Write to SRAM
• I2C parts are standard MCP23017 drivers which are supported in Arduino and most microprocessors
  • Arduino MCP23017 library
• C code driver - PSoC driver GitHub Repo
  • FrontPanel.c
  • FrontPanel.h
  • MCP23017.c
  • MCP23017.h