Difference between revisions of "ADE-MIXER"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 18: | Line 18: | ||
== Kits and Parts ADE-1 Mixer == | == Kits and Parts ADE-1 Mixer == | ||
| + | [[Kits and Parts Mixers]] | ||
* [https://kitsandparts.com/ADE.php Kits and Parts Mixer] | * [https://kitsandparts.com/ADE.php Kits and Parts Mixer] | ||
Revision as of 00:47, 26 September 2021
Contents
Features
- HF Mixer
- Micro-circuits ADE-1+
- RF Frequency from 0.5 to 500 MHz
- Low conversion loss, 5.0 dB typ.
- Excellent L-R isolation, 55 dB typ.
- Excellent IP3, 15 dBm typ.
- 50 Ohms in and out
- Pi resistor attenuator on LO input (optional)
- BNC or SMA connectors
- 49x49mm
- 4 of 4-40 mounting holes
Kits and Parts ADE-1 Mixer
- Kits and Parts Mixer
- Mixer Diplexer description
- 7 MHz RF, 40 M band
- 16 MHz LO
- Si5351A square wave drive, 50 Ohm source impedance, 1.65V peak
- 9 MHz IF
Diplexor is a bandpass/band-stop filter popularized by Joe Reisert W1JR that is used after a double Balanced Mixer to provide a 50 ohm termination to all frequencies at the mixer's IF port, and to the following amplifier stage. Maintaining a consistent load at the mixer avoids overload and Inter-Modulation Distortion (IMD) effects that these mixers are prone to when not properly terminated.
https://www.youtube.com/watch?v=zOk_0IiIgZY
Specifications
ADE-1 Schematic
Performance
Port VWSR
PCB
