DIGIO-128 Rev X4 Assembly Sheet
Revision as of 13:08, 12 February 2021 by Blwikiadmin (talk | contribs) (→DIGIO-64 - 64-bit option)
Parts List
| Qty | Value | RefDes | Qty | Value | RefDes | |
|---|---|---|---|---|---|---|
| 8 | 0.1uF Cap, 0.2" pitch | C1-C8 | 1 | CONN, 2X03 | J4 | |
| 1 | 0 | R7 (option - below) | 2 | CONN, 1x4 | J2,J3 | |
| 2, (+1) | 10K (1/4W) | R1,R2, (R6 option - below) | 1 | CONN, 1x5 | J1 | |
| 1 | 1K (1/4W) | R5 | 8 | CONN, 2x10 | P1,P2,P3,P4,P6,P7,P8,P9 | |
| 2 | 2.2K (1/4W) | R3,R4 | 2 | CONN, 2X2 | P10,P5 | |
| 1 | 24LC024-I/P | U9 | ||||
| 8 | MCP23017P | U1,U2,U3,U4,U5,U6,U7,U8 |
R6/R7 Option
- R6 and R7 can be used to shift the address of the 64 bit version of the card from 0x20-0x23 up to 0x24-0x27
- R6 pulls up A2 to Vcc (only if R7 is not installed) (64-bits only)
- R7 provide pull-up or pull-down for I2C address A2 line
- R7 is 0 ohm jumper
- R6 is 10K resistor
DIGIO-128 - 128-bit option
- Leave R6 open (no resistor)
- Install jumper wire into R7
DIGIO-64 - 64-bit option
- Typical Operation - for I2C address = 0x20-0x23 leave R6 open, install jumper wire into R7
- For I2C address = 0x24-0x27 leave R7 open, install 10K resistor in R6
- I2C chips get installed into top 4 locations
