Difference between revisions of "Kits and Parts Mixers"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 14: | Line 14: | ||
*** [[Crystal Filter Design#SSB 4 Crystal Filter on Kits and Parts Board|SSB4 Crystal filter]] | *** [[Crystal Filter Design#SSB 4 Crystal Filter on Kits and Parts Board|SSB4 Crystal filter]] | ||
*** [[Crystal_Filter_Design#CW 5 Crystal Filter on Kits and Parts Board|CW5 Crystal Filter]] | *** [[Crystal_Filter_Design#CW 5 Crystal Filter on Kits and Parts Board|CW5 Crystal Filter]] | ||
| − | |||
| − | |||
| − | |||
[[file:ADE-1.SCH.png]] | [[file:ADE-1.SCH.png]] | ||
| Line 29: | Line 26: | ||
* Full Diplexer at the IF Port | * Full Diplexer at the IF Port | ||
* Optional Attenuators for RF & LO Ports | * Optional Attenuators for RF & LO Ports | ||
| + | |||
| + | == Diplexer == | ||
| + | |||
| + | * [https://www.changpuak.ch/electronics/calc_16a.php Diplexer Calculator (Bridged Tee) Diplexer Calculator] | ||
| + | |||
| + | <blockquote>Diplexor is a bandpass/band-stop filter popularized by Joe Reisert W1JR that is used after a double Balanced Mixer to provide a 50 ohm termination to all frequencies at the mixer's IF port, and to the following amplifier stage. Maintaining a consistent load at the mixer avoids overload and Inter-Modulation Distortion (IMD) effects that these mixers are prone to when not properly terminated.</blockquote> | ||
| + | |||
| + | https://www.youtube.com/watch?v=zOk_0IiIgZY | ||
Revision as of 00:58, 26 September 2021
Kits and Parts ADE-1 Mixer
- All Ports are 50Ω
- +7dBm Local Oscillator Injection Design
- Full Diplexer at the IF Port
- Optional Attenuators for RF & LO Ports
- Kits and Parts Mixer
- Mixer Diplexer description
- 7 MHz RF, 40 M band
- 16 MHz LO
- Si5351A square wave drive, 50 Ohm source impedance, 1.65V peak
- 9 MHz IF
Kits and Parts Diode Mixer
- Double Balanced Diode Ring Mixer Kit
- All Ports are 50Ω
- +7dBm Local Oscillator Injection Design
- Full Diplexer at the IF Port
- Optional Attenuators for RF & LO Ports
Diplexer
Diplexor is a bandpass/band-stop filter popularized by Joe Reisert W1JR that is used after a double Balanced Mixer to provide a 50 ohm termination to all frequencies at the mixer's IF port, and to the following amplifier stage. Maintaining a consistent load at the mixer avoids overload and Inter-Modulation Distortion (IMD) effects that these mixers are prone to when not properly terminated.
