Difference between revisions of "Kits and Parts Mixers"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 1: | Line 1: | ||
| − | == | + | == Common Features == |
* All Ports are 50Ω | * All Ports are 50Ω | ||
| Line 5: | Line 5: | ||
* Full Diplexer at the IF Port | * Full Diplexer at the IF Port | ||
* Optional Attenuators for RF & LO Ports | * Optional Attenuators for RF & LO Ports | ||
| + | |||
| + | == Kits and Parts ADE-1 Mixer == | ||
| + | |||
* [https://kitsandparts.com/ADE.php Kits and Parts Mixer] | * [https://kitsandparts.com/ADE.php Kits and Parts Mixer] | ||
* 7 MHz RF, 40 M band | * 7 MHz RF, 40 M band | ||
Revision as of 01:01, 26 September 2021
Contents
Common Features
- All Ports are 50Ω
- +7dBm Local Oscillator Injection Design
- Full Diplexer at the IF Port
- Optional Attenuators for RF & LO Ports
Kits and Parts ADE-1 Mixer
- Kits and Parts Mixer
- 7 MHz RF, 40 M band
- 16 MHz LO
- Si5351A square wave drive, 50 Ohm source impedance, 1.65V peak
- 9 MHz IF
Kits and Parts Diode Mixer
- Double Balanced Diode Ring Mixer Kit
- All Ports are 50Ω
- +7dBm Local Oscillator Injection Design
- Full Diplexer at the IF Port
- Optional Attenuators for RF & LO Ports
Bridged Tee Diplexer
Diplexor is a bandpass/band-stop filter popularized by Joe Reisert W1JR that is used after a double Balanced Mixer to provide a 50 ohm termination to all frequencies at the mixer's IF port, and to the following amplifier stage. Maintaining a consistent load at the mixer avoids overload and Inter-Modulation Distortion (IMD) effects that these mixers are prone to when not properly terminated.
