Difference between revisions of "Kits and Parts Mixers"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 16: | Line 16: | ||
*** [[Crystal Filter Design#SSB 4 Crystal Filter on Kits and Parts Board|SSB4 Crystal filter]] | *** [[Crystal Filter Design#SSB 4 Crystal Filter on Kits and Parts Board|SSB4 Crystal filter]] | ||
*** [[Crystal_Filter_Design#CW 5 Crystal Filter on Kits and Parts Board|CW5 Crystal Filter]] | *** [[Crystal_Filter_Design#CW 5 Crystal Filter on Kits and Parts Board|CW5 Crystal Filter]] | ||
| + | |||
| + | ==== Toroid Winding Direction ==== | ||
| + | |||
| + | * Toroids needs to be wound to match the pad locations on tje PCB | ||
| + | |||
| + | [[file:toroid-cw.jpg]] | ||
== Kits and Parts ADE-1 Mixer == | == Kits and Parts ADE-1 Mixer == | ||
Revision as of 19:16, 26 September 2021
Contents
Kits and Parts Mixers Features in Common
- All Ports are 50Ω
- +7dBm Local Oscillator Injection Design
- Full Diplexer at the IF Port
- Optional Attenuators for RF & LO Ports
- Available as bare PCB or kit of parts
My Applications
- 7 MHz RF, 40 M band
- 16 MHz LO
- Si5351A square wave drive, 50 Ohm source impedance, 1.65V peak
- 9 MHz IF feeds Crystal Filter
Toroid Winding Direction
- Toroids needs to be wound to match the pad locations on tje PCB
Kits and Parts ADE-1 Mixer
- Kits and Parts Mixer
- Build and tune diplexer first
Kits and Parts Diode Mixer
- Double Balanced Diode Ring Mixer Kit
- Build and tune diplexer first
Bridged Tee Diplexer
Diplexor is a bandpass/band-stop filter popularized by Joe Reisert W1JR that is used after a double Balanced Mixer to provide a 50 ohm termination to all frequencies at the mixer's IF port, and to the following amplifier stage. Maintaining a consistent load at the mixer avoids overload and Inter-Modulation Distortion (IMD) effects that these mixers are prone to when not properly terminated.
Videos
\
