Difference between revisions of "Kits and Parts Mixers"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 42: | Line 42: | ||
== Bridged Tee Diplexer == | == Bridged Tee Diplexer == | ||
| + | |||
| + | * LTSpice simulation | ||
| + | |||
| + | [[FILE:DIPLEXER_SPICE_SIM.PNG]] | ||
<blockquote>Diplexor is a bandpass/band-stop filter popularized by [https://www.youtube.com/watch?v=iVUv8C-8g-Y Joe Reisert W1JR] that is used after a double Balanced Mixer to provide a 50 ohm termination to all frequencies at the mixer's IF port, and to the following amplifier stage. Maintaining a consistent load at the mixer avoids overload and Inter-Modulation Distortion (IMD) effects that these mixers are prone to when not properly terminated.</blockquote> | <blockquote>Diplexor is a bandpass/band-stop filter popularized by [https://www.youtube.com/watch?v=iVUv8C-8g-Y Joe Reisert W1JR] that is used after a double Balanced Mixer to provide a 50 ohm termination to all frequencies at the mixer's IF port, and to the following amplifier stage. Maintaining a consistent load at the mixer avoids overload and Inter-Modulation Distortion (IMD) effects that these mixers are prone to when not properly terminated.</blockquote> | ||
| Line 51: | Line 55: | ||
[[file:Diplexer_pass.PNG]] | [[file:Diplexer_pass.PNG]] | ||
| − | |||
| − | |||
| − | |||
| − | |||
<video type="youtube">zOk_0IiIgZY</video> | <video type="youtube">zOk_0IiIgZY</video> | ||
Revision as of 19:48, 26 September 2021
Contents
Kits and Parts Mixers Features in Common
- All Ports are 50Ω
- +7dBm Local Oscillator Injection Design
- Full Diplexer at the IF Port
- Optional Attenuators for RF & LO Ports
- Available as bare PCB or kit of parts
My Applications
- 7 MHz RF, 40 M band
- 16 MHz LO
- Si5351A square wave drive, 50 Ohm source impedance, 1.65V peak
- 9 MHz IF feeds Crystal Filter
Toroid Winding Direction
- Toroids needs to be wound to match the pad locations on the PCB
Kits and Parts ADE-1 Mixer
- Kits and Parts Mixer
- Build and tune diplexer first
Kits and Parts Diode Mixer
- Double Balanced Diode Ring Mixer Kit
- Build and tune diplexer first
Bridged Tee Diplexer
- LTSpice simulation
Diplexor is a bandpass/band-stop filter popularized by Joe Reisert W1JR that is used after a double Balanced Mixer to provide a 50 ohm termination to all frequencies at the mixer's IF port, and to the following amplifier stage. Maintaining a consistent load at the mixer avoids overload and Inter-Modulation Distortion (IMD) effects that these mixers are prone to when not properly terminated.
Videos
\
