LED-32

From Land Boards Wiki
Jump to navigation Jump to search

Tindie-mediums.png

LED-32-P426-720px.jpg

Features

  • 32 LEDs
  • 95mm wide (ODAS width) - 55mm depth matches other ODAS cards ODAS-PSOC5 (Rev X3 or higher), DIGIO32-I2C, etc
  • 6-32 mounting holes
  • 0.1" pitch connector, 2x20 pins, Connector could be mounted to the front or rear of the card
  • (8) Ground pins (common ground)
  • 3mm LEDs

Series resistor - let us know what value you want

  • Series Resistor Values
  • Pick a series resistor value assuming the LED forward voltage is about 2V.
  • Operating with 3.3V will require a smaller resistance than operating at 5V for the same current.
  • Standard series resistor values we carry are: 120, 150, 200, 220, 240, 270, 330, 470, 560, and 1K.
  • For 5V operation and not too bright LED (comfortable value for front panels) we use 560 ohms.
  • With 3V across 560 ohms that's only 5 mA (for 560 ohm resistor). For something with a lot of LEDs if they are too bright it can get annoying.

Pinout

Pin Signal Pin Signal
1 GND 2 GND
3 GND 4 GND
5 LED0 6 LED1
7 LED2 8 LED3
9 LED4 10 LED5
11 LED6 12 LED7
13 LED8 14 LED9
15 LED10 16 LED11
17 LED12 18 LED13
19 LED14 20 LED15
21 LED16 22 LED17
23 LED18 24 LED19
25 LED20 26 LED21
27 LED22 28 LED23
29 LED24 30 LED25
31 LED26 32 LED27
33 LED28 34 LED29
35 LED30 36 LED31
37 GND 38 GND
39 GND 40 GND

Assembly Sheet