Difference between revisions of "NanoVNA"

From Land Boards Wiki
Jump to navigation Jump to search
Line 32: Line 32:
 
* Someone else's page (they added an inline connector and wired to the card)
 
* Someone else's page (they added an inline connector and wired to the card)
 
** [https://www.epanorama.net/blog/2019/09/29/battery-for-nanovna/ Adding a battery]
 
** [https://www.epanorama.net/blog/2019/09/29/battery-for-nanovna/ Adding a battery]
 +
 +
== Software ==
 +
 +
* [https://github.com/mihtjel/nanovna-saver NanoVNA Saver]
  
 
== YouTube Videos ==
 
== YouTube Videos ==

Revision as of 18:58, 25 April 2020

NanoVNA - Network Analyzer

715RBejXZJL-Half.jpg

Specifications

  • Number of Calibration Points: 101 (Fixed)
  • Number of Scanning Points: 101 (Fixed)
  • Display Tracking: 4, Marking: 4, Save Setting : 5
  • PCB: 54mm x 85.5mm x 11mm (without the size of connectors, switches)
  • Measurement Frequency: 50KHz ~ 300MHz (50KHz -900MHz, enable extended firmware)
  • RF Output: -13dbm (maximum -9dbm)
  • Frequency Accuracy: 0.5ppm
  • Measurement Range: 70dB (50kHz-300MHz), 50dB (300M-600MHz), 40dB (600M-900MHz) enable extended firmware)
  • Port SWR: 1.1
  • Display: 2.8 inch TFT (320 x240)
  • USB Interface: USB Type-C; Communications Mode: CDC (Serial)
  • Power Supply: USB 5V 120mA, built-in 400mAh electricity, maximum charging current 0.8A
  • nanovna users nanovna-users@groups.io
  • Amazon links

Adding a battery

  • My unit did not come with a battery
  • Added an ST connector and an 850 mAh LiPo battery
  • The pinout on the card was backwards from the pinout of the connector at the end of the battery wires
  • Removed the pins from the battery wire connector and flipped the pins
  • Charging looks like it's working
  • Battery is a bit too thick to screw the back on completely
  • May want to switch to larger standoffs
  • Someone else's page (they added an inline connector and wired to the card)

Software

YouTube Videos