Difference between revisions of "Noise Generator on ER-PROTO-01"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 3: | Line 3: | ||
[[file:ER-PROTO-01_NOISE_WHITE.PNG]] | [[file:ER-PROTO-01_NOISE_WHITE.PNG]] | ||
| − | * Blue | + | * Blue Noise |
| − | [[file:ER-PROTO- | + | [[file:ER-PROTO-01_NOISE_BLUE.PNG]] |
| + | |||
| + | * Pink Noise | ||
| + | |||
| + | [[file:ER-PROTO-01_NOISE_PINK.PNG]] | ||
* U1 Power | * U1 Power | ||
| Line 11: | Line 15: | ||
[[file:ER-PROTO-01_U1_PWR.PNG]] | [[file:ER-PROTO-01_U1_PWR.PNG]] | ||
| − | * | + | * Jacks |
| − | [[file:ER-PROTO- | + | [[file:ER-PROTO-DB-01_J38.png]] |
== Connectors == | == Connectors == | ||
| − | * | + | * J1 = White |
| − | + | * J3 = | |
| − | |||
| − | |||
== Build == | == Build == | ||
Revision as of 20:56, 15 November 2022
- White Noise Generator
- Blue Noise
- Pink Noise
- U1 Power
- Jacks
Connectors
- J1 = White
- J3 =
Build
On Controls Card
- Install J1, J3, J4
- Wire J1-S to J3-S
- Wire J3-S to J4-S
On Daughtercard
- Wire J38-3 or J38-5 to nearby GND
- Install U1 14 pin socket near "middle of card
- Pin 4 goes towards +12V
- Add 10 Ohm resistor U1-4 to +12V
- Add jumper U1-11 to GND
- Add jumper U1-8 to U1-9 (Blue loopback)
- Add jumper U1-6 to U1-7 (White loopback)
- Install R16 1K J1-8 to Open bus row (J1-T) - White noise out
- Install R23 1K J3-6 to Open bus row (J3-T) - Blue noise out
- Install R22 1K J4-4 to Open bus row (J4-T) - Pink noise out
- Add wire U1-8 to R23 (new row)
- Add wire U1-14 to R22 (new row)
- Add wire U1-7 to R16 (new row)
- Add wire U1-1 to U1-5 (NOISE_WB)
