Difference between revisions of "QT Py"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
| Line 1: | Line 1: | ||
[[File:QT_Py_4600-06.jpg]] | [[File:QT_Py_4600-06.jpg]] | ||
| + | |||
| + | * Same size, form-factor, and pin-out as Seeed Xiao | ||
| + | * ATSAMD21E18 32-bit Cortex M0+ - 48 MHz 32 bit processor with 256KB Flash and 32 KB RAM | ||
| + | * Native USB supported by every OS - can be used in Arduino or CircuitPython as USB serial console, MIDI, Keyboard/Mouse HID, even a little disk drive for storing Python scripts. | ||
| + | * Can be used with Arduino IDE or CircuitPython | ||
| + | * Built in RGB NeoPixel LED | ||
| + | * 11 GPIO pins: | ||
| + | ** True analog output on one I/O pin - can be used to play 10-bit quality audio clips in Arduino (CircuitPython does not have storage for audio clips) | ||
| + | ** 9 x 12-bit analog inputs (SDA/SCL do not have analog inputs) | ||
| + | ** 1 x Optional AREF on A1 | ||
| + | ** 9 x PWM outputs (A0 is analog out, A1 is not PWM capable) | ||
| + | ** Hardware I2C port with STEMMA QT plug-n-play connector | ||
| + | ** Hardware UART | ||
| + | ** Hardware SPI | ||
| + | ** Hardware I2S | ||
| + | ** 6 x Capacitive Touch with no additional components required | ||
| + | * 3.3V regulator with 600mA peak output | ||
| + | * Optional SOIC-8 SPI Flash chip on bottom | ||
| + | * Reset switch for starting your project code over or entering bootloader mode | ||
| + | * USB Type C connector | ||
| + | * Really really small | ||
* Flash EEPROM 2 MB | * Flash EEPROM 2 MB | ||
Revision as of 10:12, 31 January 2021
- Same size, form-factor, and pin-out as Seeed Xiao
- ATSAMD21E18 32-bit Cortex M0+ - 48 MHz 32 bit processor with 256KB Flash and 32 KB RAM
- Native USB supported by every OS - can be used in Arduino or CircuitPython as USB serial console, MIDI, Keyboard/Mouse HID, even a little disk drive for storing Python scripts.
- Can be used with Arduino IDE or CircuitPython
- Built in RGB NeoPixel LED
- 11 GPIO pins:
- True analog output on one I/O pin - can be used to play 10-bit quality audio clips in Arduino (CircuitPython does not have storage for audio clips)
- 9 x 12-bit analog inputs (SDA/SCL do not have analog inputs)
- 1 x Optional AREF on A1
- 9 x PWM outputs (A0 is analog out, A1 is not PWM capable)
- Hardware I2C port with STEMMA QT plug-n-play connector
- Hardware UART
- Hardware SPI
- Hardware I2S
- 6 x Capacitive Touch with no additional components required
- 3.3V regulator with 600mA peak output
- Optional SOIC-8 SPI Flash chip on bottom
- Reset switch for starting your project code over or entering bootloader mode
- USB Type C connector
- Really really small
- Flash EEPROM 2 MB
