Difference between revisions of "RPI-MDI"

From Land Boards Wiki
Jump to navigation Jump to search
(Created page with "== Features == * Raspberry Pi daughtercard * Fits on "old" Model B or "new" Model B Plus board * Three axis Servo PWM outputs (Servos not included) * Two PWM Controlled LEDs...")
 
Line 1: Line 1:
 +
[[File:RPI-MDI-X2_5360-640px.jpg]]
 +
 
== Features ==
 
== Features ==
  

Revision as of 22:38, 29 December 2019

RPI-MDI-X2 5360-640px.jpg

Features

  • Raspberry Pi daughtercard
  • Fits on "old" Model B or "new" Model B Plus board
  • Three axis Servo PWM outputs (Servos not included)
  • Two PWM Controlled LEDs
  • I2C controlled 16-channel PWM controller PCA9685
  • 5 channels used as above (Three Servo outputs, 2 LED outputs)
  • PWM controller has internal built-in clock generator - no refresh required
  • Even though the Raspberry Pi has 3.3V I/O, the PWM outputs run at 5V - compatible with typical servos
  • Three switch inputs with on-board pull-ups which can be used as GPIO lines
  • 3X of 10 uF SMT capacitors on rear of board for PWM/Servo noise reduction
  • Right angle connectors for Low Profile
  • Recessed connectors for side connectors for smallest form factor
  • Very small size 1.4" x 1"
  • Jumper to use 5V from Raspberry Pi (if your power supply has sufficient capacity) or pads for external power or additional capacitance if needed
  • Python PWM - Adafruit driver