Difference between revisions of "STM32"

Revision as of 11:58, 6 February 2021

Warning: The +5V pins on this board are directly connected to the +5V pin of the USB connector. There is no protection in place. Do not power this board through USB and an external power supply at the same time.
Upper right pin is GND on Blue pill card, but is 5V on Black pill card
Reset is on a different pin
Some IO pins are om different spots

@@ Line 14: / Line 14: @@
 [[File:Blue-vs-Black-Pill-Pin-Layout.png]]
-== Arduino IDE ==
-* [https://github.com/rogerclarkmelbourne/Arduino_STM32 Hardware files to support STM32 boards, on Arduino IDE 1.8.x including LeafLabs Maple and other generic STM32F103 boards]
-** [https://github.com/rogerclarkmelbourne/Arduino_STM32/wiki Arduino STM32 Wiki]
-** [https://github.com/rogerclarkmelbourne/Arduino_STM32/wiki/Installation Installation]
-* [https://www.instructables.com/id/Programming-STM32-Blue-Pill-Via-USB/ Arduino Alternative - STM32 Blue Pill Programming Via USB]
-=== Uploading Code to Blue Pill ===
-* FTDI connection to Blue Pill Hub FTDI connector
-** FTDI TX (to Blue Pill RX) (PA10 pin on STM32)
-** FTDI RX (to Blue Pill Tx) (PA9 pin on STM32)
-* Set Switch (or jumper) on Blue Pill module set towards center of card to upload card to board
-[[File:BluePill_Jumper.png]]
-* In Arduino IDE,
-** Tools
-*** Board "Generic..."
-*** Upload method: "Serial..."
-*** Port: [the comm port]
-[[File:ArduinoIDE_Tools_Menu.png]]
-* Upload code
-** Takes a while
-* Set Switch (or jumper) on Blue Pill module set towards edge of card to run
-* Press reset button
 == Black Pill Programming ==