Synth Mod Designs

From Land Boards Wiki
Revision as of 14:33, 26 October 2022 by Blwikiadmin (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Overview

  • Good for prototyping, but not Eurorack
  • Stackable via standoffs
  • 100mm wide
  • 47mm deep
  • 4-40 mounting holes

MOD-SCF-JACKS

MOD-CF-JACKS

MOD-SCF-JACKS FRONT 3D.png

MOD-CF-JACKS FILTER J5.PNG

MOD-CF-JACKS FILTER SCHEM.PNG

MOD-DIY

MOD-DIY

MOD-DIY FRONT 3D.png

  • DIY "breadboard"
  • Rear pins bs to top/bottom
  • Extra connections on edge
  • Busses marked on silkscreen
  • (2) Horizontal busses in center for power/ground

MOD-MIDI-THRU

MOD-MIDI-THRU

MOD-MIDI-THRU FRONT 3D.png

  • DIN-5 in
  • (4) TRS Type A outs

MOD-NANO-CPU

MOD-NANO-CPU

MOD-NANO-CPU FRONT-3D.png

  • Arduino NANO
  • Runs MOZZI Arduino library
    • MOZZI audio output
    • Standard or HiFi
  • MIDI In on TRS Type A
  • Remove J4 (EN_MIDI) when USB is plugged into NANO CPU

MOD-POTS

MOD-POTS

MOD-POTS FRONT 3D.png

  • 4 pots
    • Type A = "Audio" log pots
      • Used for Volume controls
    • Type B = Linear pots
      • Used for CV
  • All pins brought to connector
  • Headers to optionally pull pot ends up/down
  • Can be used as controls (end pulled up/down or volume controls (CW, CCW brought to pins)
  • Optional R/C filter

MOD-XIAO-RP2040-CPU

MOD-XIAO-RP2040-CPU

MOD-XIAO-RP2040-CPU FRONT-3D.png

  • XIAO RP2040 CPU
  • MIDI In on TRS Type A
  • (4) Analog Inputs or Digital GPIO
  • (7) Digital GPIO
  • SD Card on RP2040 SPI bus