Difference between revisions of "VFO-001"

Revision as of 12:49, 30 October 2020

Features

DD1306 OLED Display
- I2C Interface
- OLED runs from 3.3V (can run from 5V but this use has 3.3V)
Rotary Encoder Break Out Board
STM32 (Blue Pill Board) Microprocessor
- Arduino compatible
- 3.3V
Si5351 Oscillator Breakout Board
- 10 KHz - 40 MHz tuning range
  - 100Hz/1KHz/10KHz/100KHz/1MHz/10MHz steps
- I2C Interface
- 3 Outputs
- 27 MHz crystal
- 3.3V operation works without level shifters for I2C*
- Si5351 can only run from 3.3V
Used right angle headers and Dupont cables for low profile
Replaced BOOT 0,1 jumpers
- Wire jumper on BOOT1
- Switch on BOOT0 - easier to download code
Programmed via Arduino IDE
- Download via serial
Extruded Aluminum Enclosure Box - 94mm x 83mm x 30mm - Out of stock

Schematic

Parts for Reference

Blue Pill Card

Blue Pill Card

128x32 OLED

Ebay

Libraries/Example Code

U8G2_SSD1306_128X32_UNIVISION_F_HW_I2C u8g2(U8G2_R0, /* reset=*/ U8X8_PIN_NONE);   // STM32, Ebay OLED

List of Fonts

  u8g2.setFont(u8g2_font_ncenB14_tr);

Hello World Code

U8G2_SSD1306_128X32_UNIVISION_F_HW_I2C u8g2(U8G2_R0, /* reset=*/ U8X8_PIN_NONE);   // STM32, Ebay OLED

void setup(void) {
  u8g2.begin();
}

void loop(void) {
  u8g2.clearBuffer();			// clear the internal memory
  u8g2.setFont(u8g2_font_ncenB08_tr);	// choose a suitable font
  u8g2.drawStr(0,10,"Hello World!");	// write something to the internal memory
  u8g2.sendBuffer();			// transfer internal memory to the display
  delay(1000);  
}