Difference between revisions of "XIAO ESP32C3"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) |
Blwikiadmin (talk | contribs) |
||
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
+ | [[file:ESP32C3_card.png]] | ||
+ | |||
== Features == | == Features == | ||
Line 6: | Line 8: | ||
* 32-bit RISC-V | * 32-bit RISC-V | ||
* Single Core | * Single Core | ||
+ | * Floating Point Unit | ||
* Up to 160 MHz | * Up to 160 MHz | ||
* 400 KB SRAM | * 400 KB SRAM | ||
Line 15: | Line 18: | ||
* 44 μA (deep sleep mode), with 4 working modes available | * 44 μA (deep sleep mode), with 4 working modes available | ||
* 11 GPIO pins: | * 11 GPIO pins: | ||
− | + | ** 4 x 12-bit analog inputs | |
− | + | ** 11 x PWM outputs | |
− | + | ** Hardware I2C port | |
− | ** 4 x 12-bit analog inputs | ||
− | |||
− | ** | ||
− | ** Hardware I2C port | ||
** Hardware UART | ** Hardware UART | ||
** Hardware SPI | ** Hardware SPI | ||
** Hardware I2S | ** Hardware I2S | ||
− | * | + | * Arduino support - add to File > Preferences, and fill "Additional Boards Manager URLs" |
+ | ** https://raw.githubusercontent.com/espressif/arduino-esp32/gh-pages/package_esp32_dev_index.json | ||
+ | * 3.3V regulator, you can draw 700mA | ||
+ | * LiPo charger (pads on bottom) | ||
* Reset switch for starting your project code over or entering bootloader mode | * Reset switch for starting your project code over or entering bootloader mode | ||
* USB Type C connector | * USB Type C connector |
Latest revision as of 13:46, 8 July 2022
Features
- SeeedStudio XIAO ESP32C3 Product Page (New 2022-07)
- Wiki
- ESP32C3 Datasheet
- 32-bit RISC-V
- Single Core
- Floating Point Unit
- Up to 160 MHz
- 400 KB SRAM
- 4 MB Flash
- 2.4GHz Wi-Fi subsystem
- U.FL antenna provided that supports WiFi/Bluetooth connection over 100m
- Supports Station mode, SoftAP mode, SoftAP & Station mode, and promiscuous mode
- 21 x 17.5mm overall dimension
- 44 μA (deep sleep mode), with 4 working modes available
- 11 GPIO pins:
- 4 x 12-bit analog inputs
- 11 x PWM outputs
- Hardware I2C port
- Hardware UART
- Hardware SPI
- Hardware I2S
- Arduino support - add to File > Preferences, and fill "Additional Boards Manager URLs"
- 3.3V regulator, you can draw 700mA
- LiPo charger (pads on bottom)
- Reset switch for starting your project code over or entering bootloader mode
- USB Type C connector