Difference between revisions of "SYNTH-MIXER6-01"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) (→Rev 1) |
Blwikiadmin (talk | contribs) (→Rev 1) |
||
| Line 15: | Line 15: | ||
* Connector card is too big | * Connector card is too big | ||
** Cut off J1/RV1 | ** Cut off J1/RV1 | ||
| + | ** Use RV7 as output pot | ||
| + | ** Use J7 as output jack | ||
| + | * Re-label panel using P-Touch label | ||
| + | ** Cover top holes/silkscreen | ||
| + | ** Other holes IN 1-IN 5, OUT | ||
** Skip IN 1 holes | ** Skip IN 1 holes | ||
** Cut S/S trace J7 to RV7 | ** Cut S/S trace J7 to RV7 | ||
** Do not install R6 | ** Do not install R6 | ||
** 1K from J7 (pin towards center of card to U2-7 | ** 1K from J7 (pin towards center of card to U2-7 | ||
| + | *** Use unused pad of R6 to route wire from top to bottom | ||
| + | * RV7 center goes to ground R6 pad | ||
| + | * Isolate J7 tip switch | ||
| + | ** Cut pin or isolate grounds on both sides | ||
* Should have put the pots on the left and jacks on the right | * Should have put the pots on the left and jacks on the right | ||
| − | |||
[[FILE:SYNTH-MIXER6-01_Rework.PNG]] | [[FILE:SYNTH-MIXER6-01_Rework.PNG]] | ||
Revision as of 11:45, 13 October 2022
6 Channel Mixer
- Eurorack 6HP
- Adapted from HAGIWO's 5 Channel Mixer Module
- Rear card is too tall to fit in rack between rails
- Try tilting it in?
- Views: Front (controls), Parts side, Front Panel
Issues
Rev 1
- Connector card is too big
- Cut off J1/RV1
- Use RV7 as output pot
- Use J7 as output jack
- Re-label panel using P-Touch label
- Cover top holes/silkscreen
- Other holes IN 1-IN 5, OUT
- Skip IN 1 holes
- Cut S/S trace J7 to RV7
- Do not install R6
- 1K from J7 (pin towards center of card to U2-7
- Use unused pad of R6 to route wire from top to bottom
- RV7 center goes to ground R6 pad
- Isolate J7 tip switch
- Cut pin or isolate grounds on both sides
- Should have put the pots on the left and jacks on the right
