SYNTH-MIXER6-01

6 Channel Mixer

• Eurorack 6HP
• Adapted from HAGIWO's 5 Channel Mixer Module
• Rear card is too tall to fit in rack between rail
• Hacksaw off top of card - remove J1, J2, RV1, RV2 to make 4 in mixer
  • Too tight at the bottom, need to hack off J2, RV2
• Move up holes when mounting card to panel
• Views: Front (controls), Parts side, Front Panel

Issues

Rev 1

• Connector card is too big to fit between mounting rails
  • Hacksaw off J1/RV1 by clamming between boards in vice
  • Sand end of board
  • Front and back fill are both GND on this card
  • Deletes J1, RV1, R9, R10
  • Use RV7 as output pot
  • Use J7 as output jack
  • Cut S/S trace J7 to RV7
• Isolate J7 tip switch
  • Cut pin or isolate grounds on both sides
  • Do not install R6
  • 1K from J7 (pin towards center of card to U2-7
    • Use unused pad of R6 to route Kynar wire from top to bottom
• RV7 center goes to ground R6 pad
• Should have put the pots on the left and jacks on the right
• Re-label panel using P-Touch label
  • Cover OUT holes/silkscreen at top of panel
• Re-label IN6 as OUT

Assembly Sheet

• SYNTH-MIXER6-01 Rev 1 Assembly Sheet