Difference between revisions of "SYNTH-MIXER6-01"
Jump to navigation
Jump to search
Blwikiadmin (talk | contribs) (→Rev 1) |
Blwikiadmin (talk | contribs) (→Rev 1) |
||
| Line 21: | Line 21: | ||
* Should have put the pots on the left and jacks on the right | * Should have put the pots on the left and jacks on the right | ||
* RV7 center goes to round R6 pad | * RV7 center goes to round R6 pad | ||
| + | |||
| + | [[FILE:SYNTH-MIXER6-01_Rework.PNG]] | ||
== Assembly Sheet == | == Assembly Sheet == | ||
* [[SYNTH-MIXER6-01 Rev 1 Assembly Sheet]] | * [[SYNTH-MIXER6-01 Rev 1 Assembly Sheet]] | ||
Revision as of 00:43, 13 October 2022
6 Channel Mixer
- Eurorack 6HP
- Adapted from HAGIWO's 5 Channel Mixer Module
- Rear card is too tall to fit in rack between rails
- Try tilting it in?
- Views: Front (controls), Parts side, Front Panel
Issues
Rev 1
- Connector card is too big
- Cut off J1/RV1
- Skip IN 1 holes
- Cut S/S trace J7 to RV7
- Do not install R6
- 1K from J7 (pin towards center of card to U2-7
- Should have put the pots on the left and jacks on the right
- RV7 center goes to round R6 pad
