Difference between revisions of "SYNTH-MIXER6-01"

From Land Boards Wiki
Jump to navigation Jump to search
Line 20: Line 20:
 
** Do not install R6
 
** Do not install R6
 
** 1K from J7 (pin towards center of card to U2-7
 
** 1K from J7 (pin towards center of card to U2-7
*** Use unused pad of R6 to route wire from top to bottom
+
*** Use unused pad of R6 to route Kynar wire from top to bottom
 
* RV7 center goes to ground R6 pad
 
* RV7 center goes to ground R6 pad
 
* Isolate J7 tip switch
 
* Isolate J7 tip switch

Revision as of 13:13, 13 October 2022

6 Channel Mixer

  • Eurorack 6HP
  • Adapted from HAGIWO's 5 Channel Mixer Module
  • Rear card is too tall to fit in rack between rails
    • Try tilting it in?
  • Views: Front (controls), Parts side, Front Panel

SYNTH-MIXER6-01 SET FRONT 3D.png

Issues

Rev 1

  • Connector card is too big
    • Cut off J1/RV1
    • Use RV7 as output pot
    • Use J7 as output jack
    • Cut S/S trace J7 to RV7
    • Do not install R6
    • 1K from J7 (pin towards center of card to U2-7
      • Use unused pad of R6 to route Kynar wire from top to bottom
  • RV7 center goes to ground R6 pad
  • Isolate J7 tip switch
    • Cut pin or isolate grounds on both sides
  • Should have put the pots on the left and jacks on the right
  • Re-label panel using P-Touch label
    • Cover OUT holes/silkscreen at top of panel
  • Re-label IN6 as OUT

SYNTH-MIXER6-01 Rework.PNG

SYNTH-MIXER6-01 Rework PCB.PNG

Assembly Sheet