SYNTH-MIXER6-01
6 Channel Mixer
- Eurorack 6HP
- Adapted from HAGIWO's 5 Channel Mixer Module
- Rear card is too tall to fit in rack between rails
- Try tilting it in?
- Views: Front (controls), Parts side, Front Panel
Issues
Rev 1
- Connector card is too big
- Cut off J1/RV1
- Use RV7 as output pot
- Use J7 as output jack
- Re-label panel using P-Touch label
- Cover top holes/silkscreen
- Other holes IN 1-IN 5, OUT
- Skip IN 1 holes
- Cut S/S trace J7 to RV7
- Do not install R6
- 1K from J7 (pin towards center of card to U2-7
- Use unused pad of R6 to route wire from top to bottom
- RV7 center goes to ground R6 pad
- Isolate J7 tip switch
- Cut pin or isolate grounds on both sides
- Should have put the pots on the left and jacks on the right
