SYNTH-MIXER6-01

From Land Boards Wiki
Revision as of 13:19, 13 October 2022 by Blwikiadmin (talk | contribs) (→‎Rev 1)
Jump to navigation Jump to search

6 Channel Mixer

  • Eurorack 6HP
  • Adapted from HAGIWO's 5 Channel Mixer Module
  • Rear card is too tall to fit in rack between rails
    • Try tilting it in?
  • Views: Front (controls), Parts side, Front Panel

SYNTH-MIXER6-01 SET FRONT 3D.png

Issues

Rev 1

  • Connector card is too big to fit between mounting rails
    • Hacksaw off J1/RV1 by clamming between boards in vice
    • Sand end of board
    • Front and back fill are both GND on this card
    • Deletes J1, RV1, R9, R10
    • Use RV7 as output pot
    • Use J7 as output jack
    • Cut S/S trace J7 to RV7
  • Isolate J7 tip switch
    • Cut pin or isolate grounds on both sides
    • Do not install R6
    • 1K from J7 (pin towards center of card to U2-7
      • Use unused pad of R6 to route Kynar wire from top to bottom
  • RV7 center goes to ground R6 pad
  • Should have put the pots on the left and jacks on the right
  • Re-label panel using P-Touch label
    • Cover OUT holes/silkscreen at top of panel
  • Re-label IN6 as OUT

SYNTH-MIXER6-01 Rework.PNG

SYNTH-MIXER6-01 Rework PCB.PNG

Assembly Sheet